Seagate Backup Plus 4TB Portable External Hard Drive USB 3.0, Black (STDR4000100)
|Lacdo EVA Shockproof Carrying Travel Case for 2.5-Inch Portable External Hard Drive, GPS Camera and External Battery Pack
|NVIDIA Jetson TX2 Development Kit
|Seagate Expansion 8TB Desktop External Hard Drive USB 3.0 (STEB8000100)
Seagate Backup Plus Slim is an easy way to protect and share your digital life. Ready to go with up to 5TB of storage space for your most important files, the sleek and protective metal finish is available in classic black, silver, red or blue. Choose your flavor and join the millions of satisfied customers with one of Seagate’s most popular and trusted portable drive.
Most helpful customer reviews
296 of 309 people found the following review helpful.
Working, but beware of bad sectors; always keep backups!
By Milos Ivanovic
I received this drive 8 months ago and it is still working in an acceptable manner by my standards. For more details, please continue reading.
Having recently re-browsed the Amazon reviews for this product, I saw some people complaining that their drive had failed after x months having ordered it around the same time as me. This prompted me to fully check my drive's health so that I could at least be reassured that it is in full working order for the time being. I ran a read test on Windows using HD Tune Pro since that's where my drive was plugged in at the time, and the results (shown in as screenshots attached to this review) show the drive did in fact contain some bad sectors.
I ran a non-destructive write test using badblocks on Linux which, for each sector, will first read the sector and store it in memory, then write a random pattern, then read this pattern back and make sure it matches the pattern that was written, and finally restore the original contents of the sector. I had backups just in case, so I wasn't worried and was mainly doing this for science.
At the end, SMART output showed 2310 bad sectors existed on the drive. Since I waited 8 months to run this test and used the drive sparingly, it's unclear whether the sectors were always bad or if they developed over time. It also just so happens that none of the data I had stored on the drive were on these bad sectors. Despite the clear indication of potential failure, all sectors were restored to full working order after being written over. This means the sectors were really just held a weak magnetic charge, and were not permanently bad from e.g. physical damage to the platter.
As a result, the pending/offline uncorrectable sector counts were dropped to 0 and the reallocated sector count did not increase at all. If interested, I've included the entire SMART output below.
MART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 117 100 006 Pre-fail Always - 154970934
3 Spin_Up_Time 0x0003 097 096 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 568
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 070 060 030 Pre-fail Always - 11738583
9 Power_On_Hours 0x0032 098 098 000 Old_age Always - 2497 (146 170 0)
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 52
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 001 001 000 Old_age Always - 587
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 4295032834
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 054 041 045 Old_age Always - 46 (Min/Max 32/49 #8)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 0
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 9
193 Load_Cycle_Count 0x0032 096 096 000 Old_age Always - 8819
194 Temperature_Celsius 0x0022 046 059 000 Old_age Always - 46 (0 18 0 0 0)
197 Current_Pending_Sector 0x0012 100 062 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 062 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 147 (146 13 0)
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 9955309601
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 15389131969
You can see there is an error count, but no pending/uncorrectable or reallocated sectors. Although it's clear that the drive is currently working, the history of weak sectors means I will keep a close eye on it in case data ends up being written to the sectors that used to be weak, since if they become weak again, the drive will have trouble reading from them and I could start to lose data as a result.
Remember: all drives fail, no matter what make or model you buy, so always keep backups and be prepared for the inevitable.
273 of 295 people found the following review helpful.
Died during backup after less than 2 hours.
I was pleased to initially get this backup HDD, it is small, portable, clean design, with a nice black color. It was packed in an easy to open and protective box and the basic instructions were simple and clear, plug the HDD into your computer with the accompanying cord and download the Seagate Dashboard application to begin backing up. I did just that, and initially seemed to be up to a great start. The Dashboard app isn't fancy, but appeared to be sufficient to get the job done.
However, fast forward about 2 hours to ~80% backed up, and the HDD starts to occasionally beep. I was not aware the drive had any speakers so inititally I figured I had heard something outside my house. Gradually over the next 10 minutes the beeping became more and more frequent until it was obvious they were coming from the drive and were coming out about every second. I also noticed at this point the drive was no longer backing up. Thinking something was amiss, I unplugged the drive, restarted the Dashboard, and reconnected the drive. No luck, the drive was now not being recognized by my computer, either through the file system, the Device Manager, the Drive Manager, or Seagate's Dashboard application. It still made the beeping sound. I repeated this process several times, tried different ports, a different computer, a different cable, nothing worked.
Seagate tech support is totally unhelpful. I seemed to only get form emails from them. Most would not even respond to entire parts of my email, basically telling me to troubleshoot by trying different computer, restarting, etc. I found it really disheartening that a company's harddrive would fail only part of the way through it's first use. Thankfully Amazon has a fantastic return program! I would not buy from Seagate again.
1081 of 1178 people found the following review helpful.
Excellent Hard Drive - Great Price. Pull drives for use in Laptop/PS4.
By Amazon Reviewer
Hard to go wrong here. If you are using this as an external drive, this product has 2TB in very small space and is USB powered. The drive itself only takes 0.7-2.3W to operate! On Mac OSX 10.9.2 running the included Paragon NTFS driver, I was able to see write rates in 8-10 MB/sec with USB 2.0. On a Windows 7 Machine I averaged 18 MB/Sec; 14 MB/sec running the latest 8.1 update.
I pulled the drives from two of these units (instructions below - photos to be added soon) for use in my laptop. This product is the only way I know of to obtain the 9.5mm tall, 2.5-in 2T Samsung Spinpoint M9T drive(s). Note: the 2TB version has 1 drive, the 4TB has 2 drives. After installing them in my laptop (has 3 internal HDD bays with SATA connections, 1st bay has OS, apps, etc. on 500GB SSD), I tested data txfr speeds. I moved 1.5 TB of data from one drive to another with average speeds of 194 MB/Sec in Windows 8.1. Laptop now has 4.5 TB of hard drive capacity.
Have also successfully installed one in a PS4! Next project will be to install one in a Macbook Pro. Great way to get a lot of internal storage space for little money (Purchased early April 2014 for $103.99 directly from Amazon with 2-day Prime shipping).
Removal Instructions (WARNING -THIS WILL VOID YOUR WARRANTY - BUYER BEWARE):
1. Obtain small, flat-bladed screw driver and gently insert between the aluminum top and the plastic bottom.
2. Rotate screwdriver slightly to pry the top off. At this point slide the screwdriver around the perimeter and the top will come off.
3. Once the top is off, you will see the top of the internal drive. Carefully remove from the plastic lower without prying or subjecting the drive to significant shock. It is easiest to remove by lifting the side opposite the USB connector.
4. Once the drive is out of the plastic enclosure, you'll need to remove some aluminum tape and wax paper from the drive. Be careful when doing this to avoid ESD which may damage drive circuitry.
5. Once the tape and paper are removed, the USB to SATA board can be carefully removed from the drive. It is an interference fit without any fasteners.
6. You now have a bare 2TB, Samsung Spinpoint M9T drive that is only 9.5 mm tall! Great for laptops and the PS4.
7. Install in your new device per your device manufacturer's instructions.